Hi Doug,
Thank you for your valuable advice. I'm not sure what an Action Engine is, I tried using the labview search button to find it but unfortunately no results. Can you please tell me where exactly would the AE be placed in the block diagram, I don't really get why would I need a case structure or an AE. When I start this program the DAQ will continuously be generating a PWM signal right until I halt right?
About the duty cycle, I really need a 50% duty cycle, but when I set it to 50, I get this error:
Error -200077 occurred at Property Node DAQmx Channel (arg 3) in DAQmx Create Channel (CO-Pulse Generation-Frequency).vi:1->Daqmx.vi,
It says that:
Requested Value: 50.0
Valid Values Begin with: 119.209297e-9
Valid Values End with: 999.999881e-3
That's why the d/c was set to a strange value of -5. If you can please edit the VI into what you see is best and send it back to me that would be terrific. Thank you very much!!