Hello all,
first I want to excuse my really late answer. But in the last days, we were really busy (as usual).
Yesterday I got the time to run a repair over my labview installation. Since then, the function 'Quit LabVIEW' is working.
The next step will be, to find out why I need the 'Quit LabVIEW'. I had also some time yesterday, to play around with 'Open' and 'Close'
VIs. And after closing all open FPs the application I built from my test project was just quitting and closing. So I should not need the 'Quit LabVIEW'.
Regards
Heinrich Eidloth
↧